Vectronics VEC-1604K - Manual (Page 13)

VEC-1604K Owner's Manual Portable CD Amplifier Kit
11
! ! 38. Connect the free end of the insulated wire from L-OUT to the TIP tab
on the jack.
Next, install the Right-Channel Speaker Jack:
! ! 39. Find the 3" length of insulated wire connected to GND3. Solder the
free end to the common or GND tab on a 3.5-mm stereo jack.
! ! 40. Cut and prep a 4" length of insulated wire. Connect one end to R-
OUT and solder.
! ! 41. Connect the free end of the insulated wire from R-OUT to the TIP tab
on the jack.
Finally, install the CD-Player Stereo Input connector.
! ! 42. Find the 4" length of insulated wire connected to GND2. Solder the
free end to the common or GND tab on the last 3.5-mm stereo jack.
! ! 43. Cut and prep a 3-1/2" length of insulated wire. Connect one end to L-
IN and solder.
! ! 44. Connect the free end of the insulated wire from L-IN to the TIP tab
and solder.
! ! 45. Cut and prep a 2" length of insulated wire . Connect one end to R-IN
and solder.
! ! 46. Connect the free end of the insulated wire from R-IN to the RING tab
and solder (see diagram).
If you have the companion VEC-1604KC cabinet kit, you'll mount the 2.1-mm
power jack in the panel prior to connecting the power leads to from the PC
board. If you plan to install your kit in a different box, go ahead and install the
power jack at this time so you can test your unit. The power jack has three
solder tabs on the back, as shown below:
red (+)
black (-)
! ! 47. Find the 2" red wire connected to PWR. Connect the free end to the
(+) tab of the power jack, as shown. Solder.
! ! 48. Find the 2-1/2" length of insulated wire connected to GND1. Connect
the free end to the (-) tab of the power jack, as shown. Solder.