Vectronics PM-30UV - Manual (Page 2)

PM-30UV SWR/Power Meter Owner's Manual
2
REAR PANEL CONNECTIONS
RF OUTPUT ........................................ SO-239 connector (PM-30UV)
N-connector
(PM-30UVN)
BNC connector (PM-30UVB)
RF INPUT ............................................ SO-239 connector (PM-30UV)
N-connector
(PM-30UVN)
BNC connector (PM-30UVB)
POWER................................................ 2.5mm coaxial type jack
INSTALLATION
1. Connect the
RF INPUT to the transmitter using the appropriate
connectors. If using an antenna tuner, the PM-30UV should be
placed between the transmitter and antenna tuner.
2. Connect the
RF OUTPUT to the antenna using the appropriate
connector. If using an antenna tuner, the RF OUTPUT is connected
to the antenna tuner input.
Note: Vectronics recommends using high quality cable for all
connections.
3. If a lighted meter is desired, a 9-12Vdc power supply, such as the
Vectronics AC-12, must be connected to the jack labeled POWER on
the back of the unit. This is a 2.5mm coaxial type jack with the
center positive.
OPERATION
1. Set the PM-30UV to the proper band by pressing the appropriate
switch (144/220/440) . To more accurately display RF power
in the amateur bands that lie in the 100-500 MHz range, is the
reason
144 , 220 , and 440 option switches are provided on the
front panel. This wattmeter is, however, usable at frequencies other
than the 3 front panel option ranges. See the CALIBRATION
section for more information.