Danby DWC2727BLS - Manual (Page 11)

Before You Call For Service
If none of the above rectify the situation please contact our customer care department
at 1-800-26- (1-800-263-2629)
10
Trouble Shooting
Problem Possible Cause What to do
No Power. A fuse in your home may Replace fuse or reset circuit breaker.
be blown or the circuit
breaker tripped.
Power surge. Unplug the wine cooler, wait a few
seconds and then plug it back in.
Plug not fully inserted into Make sure the 3-prong plug on the
wall outlet wine cooler is fully inserted into outlet.
Cabinet Temperature Temperature setting Verify the temperature control setting.
too High adjust if neccessary.
Door(s) not shut properly Ensure that the doors are fully closed
or opened excessively and that the gaskets are sealing,
against the cabinets. Open the doors
only as needed and for short periods
of time.
Exhaust vent is obstructed Verify there is nothing blocking the
front mounted exhausting vent.
Recently added a large Limit the quantity of warm bottles
quantity of warm bottles being introduced to the cabinet at the
to the cabinet same time. Attempt to phase in the
load introduction if possible. (i.e. load
no more than 6 warm bottles at once-
3 per compartment)
“Clicking” Noise Normal sound No user intervention is required as
this sound is normal during the opera
tion of the appliance. This audible
‘clicking’ noise may be heard as the
wine cooler ends or begins a cooling
cycle.
Condensation on the High humidity conditions The condensation will subside once
cabinet and/or doors in the home. humidity conditions return to normal.
Door(s) not shut properly Ensure that the doors are fully closed
or opened excessively and that the gaskets are sealing.
against the cabinets. Open the doors
only as needed and for short periods
of time.