Dove Systems IQ 512 - Manual (Page 2)

2
Contents
Introduction............................................................................................................3
Quick Start.............................................................................................................3
Making A Scene!...................................................................................................4
Lights Out!.............................................................................................................4
Using the Menu......................................................................................................5
Setting Default Patch.............................................................................................5
Clearing the Patch Table........................................................................................5
Patching Channels To Dimmers............................................................................6
Patching Dimmers to Channels..............................................................................6
LIMITED WARRANTY.......................................................................................8
7
Patching dimmers to channels also allows you to “set a
look” on a control channel. To do this, select Edit Patch Table ->
patch channel @ dimmer @ level. To set the first “look” on chan-
nel 1, leave channel 1 selected. Use the right arrow to move over
to selecting dimmers. Select the dimmer you wish to control (using
the up and down keys). Use the right arrow to move over to setting
levels. Use the up and down keys to adjust the level of this dim-
mer. Once this dimmer is set, use the left key to move back to se-
lecting dimmers. Use the up and down keys to select the next
dimmer to set. Use the right arrow key to move over to setting lev-
els. Again, use the up and down keys to set the level. Repeat this
until the “look” for this channel is set. You can then either use the
left key to get out of the menu, or use the right key to move to the
next control channel.
You can watch the look being built by setting the appropri-
ate control channel slider to full. For example, if you are building a
look on channel 1, set the channel 1 slider to full. As you patch
dimmers to channel 1, you’ll see the effect on stage. The DMX
output of the IQ512 will follow the adjustments as you make them.
When you start building the look for channel 2, bring channel 1 to
zero and set channel 2 to full.