ETA Linty - Manual (Page 17)

To avoid damage to the appliance, pay special attention to the following parts of
clothing:
1) Buttons and zippers 4) Thin or fine parts
2) Protruding parts of clothing 5) Stitches and fringes
3) Foreign objects on the fabric
Charging of accumulator
Turn off the appliance before connecting it to the supply chord! Plug the terminal of the
supply cord A6 into the connecting slot A8 of the delumper all the way and plug the fork
into the el. outlet. The first charging or charging after a long period of time is approx. 10
hours! The operation of charging of the accumulator is indicated by the “red” indicator A9.
When using the appliance regularly, charge it continuously for 8 hours, but no longer than
24 hours! Do not exceed the charging time given. Unplug the cord of the accumulator from
the el. outlet and appliance.
ATTENTION
– Fully charged batteries provide operation time for approx. 40 minutes.
– Do not use the delumper with the charging cord plugged in!
– If you’re charging the accumulator for the first time after being stored away for some
time, the accumulator will charge to about 60 % of total capacity. After discharging
and recharging again, the accumulator will charge to 100 %.
– After using the appliance for a long time or in hot environment, the accumulator may
be too hot for charging. Let the accumulator cool off before charging.
– To extend the lifespan of the accumulator, we recommend discharging the
accumulator completely 4x a year by normal use and then charging it fully again.
!
Using the delumper (see pic. 2)
1) Remove the protective cover A5.
2) Turn the switch A1 to turn the appliance on.
3) Put the razor strip on the surface of the fabric, removing the lumps with light movements
without pushing hard.
4) Turn the appliance off after use and replace the protective cover.
Note: Do not use the appliance on silk stockings, they would get damaged.
IV. MAINTENANCE
Turn off and unplug the appliance from the el. outlet before maintenance. Unscrew the
lump bin A4 and the protective razor strip A3 in the direction displayed in picture 3. Clean
the bin, protective razor strip and inner cover with the cleaning brush A7. Replace all
the parts reversely and assemble the appliance. Make sure all the bearing areas are
functional. Handle the inner razors carefully to avoid injuries. Do not press the outer foil of
the protective razor A3 and make sure you do not drop it. The body of the appliance can
be cleaned with a dry cloth. Do not grease the razor strip or the razors with preservative
oil to avoid staining the clothes. After cleaning, store the appliance in a dry, dustless, safe
place, out of reach of children and persons sui juris.
17
GB
/ 32