Dymo PS20DL - Manual (Page 7)

6
• Avoid shaking, dropping, or otherwise shocking the scale. This is a precision instrument and
MUST BE HANDLED WITH EXTREME CARE.
• The scale has been calibrated at the factory and will not need to be calibrated again.
Technical Specifications
For information about our other scale products, visit www.dymo.com.
Troubleshooting
If you need further assistance, contact Technical Support at (877) 724-8324. You can also
obtain support at www.dymo.com.
Capacity 20.0 pounds (9 kg)
Resolution 0.1 oz. (2 g)
Units lb./oz. (kg/g)
Auto-off After two minutes of inactivity
Operating Temperature 40° - 104° F (4.5° - 40° C)
Interface Serial
Power 120 V AC adapter or six AAA batteries
Problem/Error Message Solution
No display Ensure the scale is plugged in, or replace the batteries.
LOW BATT is displayed Replace the AAA batteries.
UNDER LOAD is displayed A Tare value was displayed and the items were removed from
the scale. Press Tare (0) to reset the scale to zero.
OVER LOAD is displayed The item on the scale platform exceeds the maximum capacity
of the scale. Remove the item immediately to prevent damage
to the scale.
Display reads 0.0 with an item on the
platform
This can happen because:
• The Tare button was pressed while an item was on the scale.
• Power to the scale was disconnected or turned off and then
on again with an item on the scale.
In both of these cases, remove the item from the platform and
press the Tare (0) button to return the display to 0.0.