Dremel 6300 - Manual (Page 16)

-16-
Accessory
MM11
Base plate for
sanding
MM411
3/8" HCS wood
flush cut blade
MM440
3/4" HCS wood
flush cut blade
MM422
3/4" BIM wood
metal flush cut
blade
MM450
3" HCS Flat
Saw Blade
MM500 MM501
Segmented
1/8", 1/16" grout
removal
MM600
Rigid scraper
blade
MM610
Flexible scraper
blade
MM900
60 grit diamond
paper
MM70P
Sand paper
MM70W
Sand paper
Material
Depends on sanding
sheet
Wood, plastic,
drywall and other
soft materials
Wood, plastic
drywall and other
soft materials
Non-ferrous metals,
wood, plastic and
other soft metals
Wood (limited use on
hard wood) plastic,
drywall and other
soft materials.
Grout joints
Vinyl, varnish and
carpeting
Caulk, adhesives,
paint and other soft
materials
Thinset, cement
and motar.
Varnish and paint
removal
Bare wood,
hardwood, softwood,
chipboard, metal
Application
Sanding surfaces close to edges, in
corners or hard to reach areas.
Depending on the sanding sheet for, e.g.,
sanding wood, paint, varnish, thinset
and cement.
Smaller cuts and flush cuts. Example:
Cut-outs in furniture for cable
connections.
Cutting and deep flush cuts; also for
sawing close to edges, in corners and
hard to reach areas.
Example: Flush cutting door jamb or
window sill, for flooring or tile installation.
Smaller cuts and plunge cuts.
Example: Sawing off water pipes
(copper) or cable ducts flush against
walls, floors or ceilings.
Cutting in existing trim or flooring. Cutting
close to edges in corners or hard to reach
areas. Examples: Installing floor vent or
repairing damaged wood flooring.
Removing grout from between wall or
floor tiles.
Example: Removing grout joints between
wall tiles for repair work.
Remove vinyl flooring and bonded
carpeting. Example: On stairs/steps or
other small/medium sized surfaces.
Scraping off old coats of varnish/paint or
other adhesive.
Removing caulk, coats of peeling paint
or soft adhesive.
Removing thinset or cement; Example:
Grinding away thinset after tile removal.
For sanding primer and removing brush
strokes, drops of paint and paint run.
For detail sanding.
Multi-Max Accessories
HCS = High Carbon Steel BiM =BiMetal
DM 2610958399 07-08.qxp 8/6/08 2:15 PM Page 16