Manual del usuario, Dispensador de agua caliente instantánea, Troubleshooting – InSinkErator C1300 User Manual

Page 7: Instalación, cuidado y uso, C1300

Advertising
background image

TROUBLESHOOTING

WHAT TO DO

Water and steam spits

forcefully from spout

without turning on the

dispenser faucet.

Water is not hot.

• Unit is boiling.

May be normal during initial setup.

• The unit may not be plugged in.

• The electric outlet is inoperative.

• Activate faucet lever to release some water from

the tank.

• Adjust water temperature using dial on tank front.
Remember that at higher altitudes, water boils

at lower temperatures.

• Make sure the unit is connected to a properly grounded

electric outlet.

• Make sure the circuit breaker or fuses are

functioning properly.

• Check that the outlet is not switched off.

Water is too hot

or not hot enough.

• Thermostat is not adjusted to

your needs.

• Adjust the thermostat slowly, then activate faucet handle

for 20 seconds to bring in fresh water to be heated at

the new setting. Allow 5-7 minutes for water to reach

new temperature.

Water comes out the

vent instead of spout.

• Outlet tube is blocked.

• Check that outlet tube is not kinked, twisted or pinched.
• Unscrew spout end piece and clean out any debris.

Water is dripping from

the spout/vent

intermittently.

• The expansion chamber isn’t

draining properly due to low

water pressure.

• The spout is blocked.

• Unplug the unit. If the dripping doesn’t stop after a few

minutes, check the supply valve to ensure that is fully

open and there are no obstructions in the water line

reducing the pressure below 30 psi (i.e., a poorly

mounted saddle valve, a clogged water filter, or a

partially opened shut-off valve).

• Unscrew spout end piece and clean out any debris.

Water is dripping

from the spout/vent

constantly.

• Debris in the water line may be

in the faucet valve seat causing a

slow water leak.

• Unscrew spout end piece and clean out any debris.
• Activate faucet lever 7-10 times to flush faucet & lines.

Water discoloration/

rusty appearance.

• Corrosion of unit.

• Unplug and drain unit as described in the Seasonal

Storage/ Drainage Section on page 8 of this manual.

If the water discoloration remains after draining and

refilling unit, discontinue use and contact an

authorized InSinkErator service agent.

PROBLEM

POSSIBLE CAUSE

If you are still experiencing trouble, visit

www.insinkerator.com/foodservice or call 1-800-845-8345.

An instant hot water dispenser, like any water heater, has a limited life and will eventually fail. To avoid

possible property damage, this instant hot water dispenser should be regularly examined for leakage and

replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak detector,

should be used in those applications where any leakage could cause property damage.

12

Dispensador de agua caliente instantánea

Manual del usuario

Instalación, cuidado y uso

Installation, Care & Use

Installation, soin et utilisation

C1300

Advertising