Laminator Direct VALUE-LAM 4500HC - 2 Roller - Manual (Page 4)

4
OPERATING INSTRUCTIONS
VALUELAM 4500HC-2
For your safety...
Do not connect the laminator to electrical power or attempt to operate it until
you have read these instructions completely. Keep these instructions in a
convenient location for future reference.
Read all safety messages located in this instruction manual and on the
laminator very carefully.
Always lower the safety shield before operating your laminator.
Removing feed table exposes hot and moving parts. This means that you can
be harmed if you remove the feed table. When the table is in the proper
position the risk of injury to the operator is reduced.
Do not operate this laminator without all detachable units installed correctly.
This means that there is risk of injury if this product is operated without all of its
parts in their proper positions.
Keep hands and clothing away from rollers. The rollers are pinch points that
can trap body parts or clothing and cause serious injury.
Do not touch the rollers while the laminator heater power is on. Turn
rollers off and allow to cool.
Do not use the laminator for other than its intended purpose.
Electrical Safeguards...
Never override or attempt to defeat electrical or mechanical safety interlock
devices.
The machine has been manufactured with a plug on the machine designed to
operate on a 110volt, 20 Ampere circuit.
Disconnect power supply before servicing your laminator.
The laminator should only be operated from the type of power source indicated
in these OPERATING INSTRUCTIONS and on the serial label located on the
rear panel of the unit.