LD Systems MEI 100 G2 - Manual (Page 9)

9
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH
1 ANTENNA
2 RF SIGNAL LED
Lights up when an RF signal is present
3 EARPHONE/HEADPHONE CONNECTOR 3.5 MM STEREO jACk
4 ON/OFF SWITCH AND VOLUME CONTROL FOR EARPHONE/
HEADPHONE OUTPUT
To switch on, turn the knob to the right (clockwise) past the snap-in
point. To switch off, turn the knob to the left (counter clockwise) past
the snap-in point.
Turning the knob to the left decreases the volume; turning it to the
right increases the volume. To avoid hearing damage, set the volume
to minimum before using the earphones/headphones, then slowly
increase the volume. Caution: high volume can cause permanent
hearing damage.
5 LC DISPLAY
6 ARROW DOWN, DECREASE VALUE
7 SET
Programming button
8 ARROW UP, INCREASE VALUE
WEARING THE BODY PACk RECEIVER
Clip the receiver to your belt or a suitable strap. For optimum fit, the
clip should always be pushed all the way over the belt and/or strap
(see illustration).
Belt clip
Open
Close
BATTERY REPLACEMENT
Press the spot marked "OPEN" on the battery compartment lid and
simultaneously push it toward the middle of the unit. The lid will
spring open and the batteries can be removed. After inserting new
batteries (battery orientation shown on rear of device), press down
the battery compartment lid down on the sport marked "CLOSE" and
push it toward the edge of the device until it engages.
With high quality batteries, it is possible to attain running times of
10 hours and more. When the LCD panel battery symbol flashes,
the batteries (type AA) should be replaced immediately. Remove the
batteries before extended periods of disuse.
5
4 3
1
2
7 8
6
BODY PACk RECEIvER: