LD Systems MEI 1000 G2 - Manual (Page 11)

11
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH
1
2
3
4
5
SYSTEM SETUp:
RECEIVER PROGRAMMING:
To change settings on the receiver, press gently on the marked
spots on the sides of the battery cover and flip it forward. The
Escape (ESC) and SET buttons are now accessible. To return to the
main menu after a setting change, press the Escape button (ESC).
1 MAIN MENU
In the main menu, the radio frequency, RF and AF level, mono /
stereo mode, EQ, limiter, as well as the lock status are displayed.
2
BALANCE
Adjust the volume balance between the left and right channels of
a stereo signal using the buttons. When the transmitter is
in mono mode, using the buttons will set the position of the
signal in the panoramic field.
3
SELECTING A FREQUENCY GROUP 1 - 8
Press the SET button repeatedly on the receiver until "GROUP"
appears and starts to flash. Press the keys to select the
desired frequency group.
4
SELECTING A CHANNEL 1 - 12
Press the SET button until "CHANNEL" appears in the display and
flashes, and then select . the desired channel using
5
EQUALIZER
Press the SET button repeatedly until "EQ" appears in the display
and flashes. Use the buttons to determine whether the
Equalizer should be enabled (EQ ON), or disabled (EQ OFF). When
the EQ is enabled, the treble at 10kHz is increased by around 6dB.