Connections, controls, and indicators – LD Systems STINGER MIX 6 A G2 User Manual
Page 7
CONNECTIONS,
CONTROLS, AND INDICATORS:
1
MIC INPUT CH1 - CH3
Balanced microphone input (XLR/ 6.3 mm jack combo) It is also possible to use an unbalanced microphone
cable (mono jack). A 15 V phantom power can be switched on (switch 22).
2
HI-Z
Using this pressure switch, the input of channel 1 (CH1) can be switched to high impedance (push switch
down for activation). Channel 1 can thus be used as a channel for instruments such as an electric guitar.
3
LINE INPUT CH4 (RCA L/R)
Unbalanced line input (RCA) for connecting an external audio source (e.g., laptop, MP3 player). A stereo
signal is mono summed internally.
4
LINE INPUT CH4 (3.5 MM STEREO JACK)
Unbalanced Line Input with a 3.5 mm stereo jack. A stereo signal is mono summed internally.
5
HIGH
Equalizer high band (12 kHz) for input channels 1 to 4 (CH1 - CH4). When turned to the left, levels are lowe-
red, when turned to the right, they are raised. In the centre position (resting point), the equalizer is inactive.
6
LOW
Equalizer low band (80 Hz) for input channels 1 to 4 (CH1 - CH4). When turned to the left, levels are lowered,
when turned to the right, they are raised. In the centre position (resting point), the equalizer is inactive.
7
LEVEL
Volume control for channels 1 to 4 (CH1 - CH4).
7
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH
LDMIX6AG2:
24
25
26