LD Systems STINGER 15 HP - Manual (Page 7)

BACK PANEL / CONTROL ELEMENTS:
1 INPUT
Both 4-pole Speakon sockets are parallel wired and can be used for both operating modes, Fullrange and
Biamping mode.
If one socket is used as Input, the other socket can be used as Link Output.
For Fullrange mode (operating mode switch 2 in position FULLRANGE) only pin 1+ and 1- of the SPEAKON
sockets are used. Frequency separation for high and low frequencies will be done by the internal passive
crossover.
For Biamping mode (operating mode switch in 2 position BIAMPING) pin 1+ and 1- of the Speakon sockets
are used for low frequencies (woofer) and pin 2+ and 2- are used for high frequencies (tweeter). Frequency
separation has to be done by an active crossover (LDDS21 or LDDPA260) before amplification (recommended
crossover frequency 1000Hz).
2 OPERATING MODE SWITCH
For Fullrange mode set to FULLRANGE.
For Biamping mode set to BIAMPING.
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH
7