Legrand RC7AP - Manual

RC7 P ok oke-Thru Abandonment Plate
Cat. No. RC7AP
INSTALLATION INSTRUCTIONS
Walker ® electrical systems conform to and should be
properly grounded in compliance with requirements of
the current National Electrical Code or codes adminis-
tered by local authorities.
All electrical products may present a possible shock or
fire hazard if improperly installed or used. Walker elec-
trical products may bear the mark as UL Listed and/or
Classified and should be installed in conformance with
current local and/or the National Electrical Code.
Products Covered: RC7APBK and RC7APVY
Punch Out Center Hole Remove Cover Attach Plate Using Screw Provided
Step 2 Step 1 Step 3
Option 1 – With Receptacle In Place:
Walker Systems, Inc.
1000 Innovation Drive, Williamstown, WV 26187
1 000 670 0700 © Copyright 2000 The Wiremold Company All Rights Reserved
Remove Cover, Receptacle and Receptacle
Wires or Conduit Adapter Assembly
Punch Out Both End Holes
Place Intumescent Wafers
Step 1
Step 2
Step 3
Attach Plate Using Screws Provided
Step 4
Option 2 – With Receptacle Out: