Legrand IC1001 - Manual

INSTRUCTION / INSTALLATION SHEET
Audio Interrupt Module
IS-0316 Rev. C
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2006 by On-Q/Legrand All Rights Reserved. Page 1 of 2
1. INTRODUCTION
The On-Q /Legrand Audio Interrupt Module, PN IC1001 (see Figure
1), is designed to compliment the inQuire™ Intercom System. It works
in conjunction with both the lyriQ™ Audio System and the inQuire™
Intercom System by automatically muting any music that is playing
through the lyriQ™ Audio System. It allows you to hear any page, or
the door chime if installed, over the inQuire™ Intercom System. If the
lyriQ™ Keypad Volume Control is installed along with a lyriQ™ Local
Source Input, the Audio Interrupt Module will also mute the local audio
source. The lyriQ™ audio will resume at the previous volume setting
approximately 15 seconds after a page and 45 seconds after a door
chime.
Figure 1
2. DESCRIPTION
The Audio Interrupt Module is used to integrate our inQuire™ Intercom and our lyriQ™ Audio Systems.
The Audio Interrupt Module gets connected to the inQuire™ Intercom Module, lyriQ™ System Source
Input, and the lyriQ™ Audio Distribution Module using RJ45 connectors. The Audio Interrupt Module will
mute the active audio from the Audio System in order to facilitate clear understanding of the Intercom
Systems' communications and door chimes.
3. INSTALLATION
NOTE: Install and verify the functionality of both the inQuire™ Intercom System and the lyriQ™ Audio
Distribution Module. All wiring must be terminated to TIA 568A standards.
IMPORTANT: Turn off power to the inQuire™ Intercom System and the lyriQ™ Audio Distribution Module.
A. Using a standard Category 5 patch cable, such as PN 363201-xx, plug in one end to the port on the
Audio Interrupt Module labeled INTERRUPT IN, and plug the other end into the port on the inQuire™
Intercom Module that is labeled AUDIO INTERRUPT OUT (see Figure 2).
B. Plug the Category 5 cable from the lyriQ™ Audio Main Source Input into the port on the Audio
Interrupt Module labeled SOURCE IN (see Figure 2).
C. Using a standard Category 5 patch cable, plug in one end to the port on the Audio Interrupt Module
labeled OUT TO AUDIO MODULE, and plug the other end into the port on lyriQ™ Audio Distribution
Module labeled SOURCE IN (see Figure 2).
D. Turn on the power to both the inQuire™ Intercom System and the lyriQ™ Audio Distribution Module
and verify correct operation.
.