Mini Tec A Kit - Manual (Page 3)

Evaporator/Heater Mounting: (Figure 1-1)
Step 1: Properly position evaporator to bottom line of lower dash (Note: Align face
plate with the contour of lower dash), and mark off location for mounting bracket
screw holes, holes for drain tubes and holes in firewall for refrigerant hoses to pass
through. Note: Sometimes it is necessary to relocate items along underside of dash to
make room for evaporator unit.
Step 2: Check for clearance on engine side of firewall. Set evaporator aside and make
holes for refrigerant hoses to pass through.
Step 3: Check for clearance on the underside of floor board. Drill a ¾” hole in floor
board for the drain tube to pass through.
Step 4: Use a small drill, approximately 5/32”, to make holes in metal framing of
under side of dash for evaporator mounting brackets. Evaporator mounting brackets
are a universal type angle bracket and may be adjusted to meet any mounting situation.
Step 5: Anchor evaporator to position. Note: It may be necessary to pre-connect
refrigerant hoses to evaporator before anchoring evaporator.