Datavideo MP-4100 - Manual (Page 42)

41
10. “ Found a new code, upgrade?” should appear on the TV Monitor; if it does not, type
the following address in IE's address input MP-4100:
http://192.168.1.175/cgi-bin/command.cgi?device=flash&command=upgrade&param1=a:\flashimg.eap
Note: You need to change 192.168.1.175 to your MP-4100's IP address
11.On TV Monitor, dialogs will popup as below “ Found a new code, upgrade?”
Please use the RMC-80 down or up key to select " " and press on the “Play” key on
RMC-80 to proceed firmware update.
12. MP-4100 will be set at video by-pass mode and a message popup "Please wait.."
13. Wait about 30 seconds; the box will automatically restart with new version software.
Notes:
a. If the upgrade is failed, the box software will not be flashed and it will reboot automatically
by last system software.
b. While MP-4100 is showing message "Please wait…", Please
DO NOT TOUCH THE MP-4100, DO NOT TURN OFF THE POWER,
Otherwise, the flash write may fail and the MP-4100 will be rendered useless!