Dynex DX-24E150A11 - Manual (Page 9)

TV components
5
DX-24E150A11
Back Remote control
## Component Description
1 ANT/CABLE IN
jack Connect an antenna, cable TV, or a satellite
box to this jack. For more information, see
“Connecting an antenna, cable TV, or
satellite TV box” on page 8.
2 PC IN AUDIO jack Connect computer audio to this jack. For
more information, see “Connecting a
computer” on page 9.
3 PC IN VGA jack Connect computer video to this jack. For
more information, see “Connecting a
computer” on page 9.
4 HDMI jack Connect an HDMI device, such as a cable
box or DVD player, to this jack. An HDMI
cable carries both video and audio, so you
do not need to make an audio connection.
For more information, see “Connecting an
HDMI device (best)” on page 8.
5 Headphone jack Plug headphones into this jack.
6 COMPONENT/AV
IN jacks Connect a component video device to
these jacks. For more information, see
“Connecting a component video device
(better)” on page 8.
7 Service port For software update only. Do not use.
# Button Description
1
(Power)
Press to turn on your TV, or wake the TV up
from DPMS mode. Press again to put your
TV in standby mode.
For more information, see “Turning your TV
on or off“ on page 11.
2 Numbers/. Press the number buttons to enter channel
numbers or the parental control password.
Press the . button to select a digital
sub-channel.
For more information, see “Selecting a
channel” on page 11.
3 RECALL Press to go to the last viewed channel.
4 VOL+ Press to increase the volume.
5 ENTER Press to confirm selections in an on-screen
menu or to open a submenu.
6 Press direction buttons to navigate in the
on-screen menus.
7 VOL– Press to decrease the volume.
8 GUIDE Press to open the DTV program guide (if
available). For more information, see
“Displaying additional information” on
page 11.
9 MENU Press to open the on-screen menu.
10 CCD Press to select a closed captioning mode.
For more information, see “Selecting the
closed captioning mode” on page 22.
DX-24E150A11_10-0762.book Page 5 Tuesday, August 31, 2010 1:17 PM