Vuzix Wrap 1200AR User Guide User Manual
Page 38
4. If you are using an application known to support side-by-side 3D, check the VR Manager
software to determine of an Extension is required for that application and if that Extension is
enabled. Each Extension is accompanied by Extension Notes to describe any special procedures
required to enable or configure that application.
Video Capture
Video is not being captured by one or both Wrap 1200AR camera.
1. Run the “AMcap” application that was installed with the Wrap AR software. Using the “Devices”
menu, select one and then the other “Vimicro USB2.0 UVC PC Camera” listings. Both should
show the image currently being captured by that camera.
2. Video capture problems can also result from the use of a USB port unable to meet the data
bandwidth demand or a poor quality USB cable. Try another USB cable and, if you are using a
USB Hub, make sure it is powered and USB 2.0 compliant.
3. If your USB is unable to meet the bandwidth requirement, lower the frame rate being used.
Head Tracking
The tracking function does not re-center correctly or drifts.
1. The Wrap Tracker requires re-calibration from time to time. Open the VR Manager software and
follow the calibration instructions provide earlier in this User Guide.
2. Magnetic interference will play havoc with a head-tracker. If you are near any substantial metal
objects or magnetic devices, like large speakers, re-positioning yourself or those objects to
lessen their magnetic interference.
Audio
I just installed my eyewear and now I don’t have any audio.
Your Wrap eyewear includes removable earphones that are recognized by Windows as a USB speaker
system. When Windows determines you have just installed a new speaker system, it automatically
configures them as your active speaker system and disables the speakers you were previously using.
1. Use the Windows Sound and Audio Devices Control Panel to select your preferred speaker
system.
2. If you wish to use an alternate speaker system, use the Windows Sound and Audio Devices
Control Panel to select that as your active speaker system.