Airaid 300-254 - Manual

Installation Instructions
For Part Numbers:
300-254
700-469 Airaid Oiled Media Filter
301-254 701-469 SynthaMax Dry Media Filter - Red
302-254 702-469 SynthaMax Dry Media Filter - Black
303-254 703-469 SynthaMax Dry Media Filter - Blue
2010-12 Dodge Ram 6.7L I6
Cummins Diesel
Component Identification
1. Airaid Premium Filter 1
2. Airaid Intake Tube 1
3. Cool Air Box 1
4. Filter Adapter 1
5. Urethane Hump Hose 1
6. Weather Strip 26 1/2” 1
7. 8/32 x 1/2” Button Head Screw 3
8. #8 Flat Washer 3
9. 1/4-20 Button Head Bolt 3
10. ¼” Flat Washer 3
11. 5/16-18 x 3/4” Hex Head Bolt 1
12. 5/16” Flat Washer 1
13. 5/16” Flange Nut 1
14. 3/8-16 Well Nut 2
15. 3/8-16 x 1 1/2” Button Head 2
16. 3/8” Flat Washer 2
17. #72 Hose Clamp 2
18. # 193 Bracket 1
2. Using a 10 mm socket, remove the nut that secures
the factory airbox, lower half, to the radiator support .
Rock the factory airbox assembly side to side to re-
lease it from it’s mounting grommets, and remove it
from the vehicle. 3. Loosen the hose clamp that secures the factory in-
take tube assembly to the rubber elbow on the turbo
inlet, and remove the assembly from the vehicle..
7. Install the Two supplied well nuts (#14) into the
factory airbox mounting holes as shown.
6. Install the bracket (#18) onto the radiator shroud as
shown using the factory hardware. Leave the bolt
slightly loose for now.
8. Install the filter adapter (#4) into the Cool Air Box,
(CAB),(#3) using thr ee 1/4” Button Head bolts (#9)
and flat washers (#10) as shown.
4. Remove the two Factory Airbox grommets and set
aside. They will not be reused. 5. Using a 13mm socket remove one bolt that secures
the fan shroud to the radiator on the passenger side of
the vehicle.
9. Install the CAB into the vehicle as shown. A.) In-
stall the 3/8” button head bolts (#15) and flat washer
(#16) thru the CAB and into the well nuts. B.) Install
the 5/16” bolt (#11) flat washer (#12), and flange nut
(#13) thru the CAB and L-bracket. Tighten all mount-
ing bolts at this time.
B.
1. Disconnect the negative battery cables.
A) Disconnect the air sensor s on the upper half of
the Factory Airbox, and detach the wire harness. B)
Loosen the hose clamp that secures the factory intake
tube assembly to the Airbox, unclip the Airbox lid,
and remove the upper half of the factory airbox from
the vehicle.
A.
A.
B.
A.
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.