Airaid 310-208 User Manual
Installation instructions
1. Disconnect the negative battery cable.
Very Carefully r emove the temper atur e sen-
sor from the factory intake tube by using a circu-
lar motion while pulling it straight out. There is
no need to disconnect the wiring harness.
2. Loosen the intake tube hose clamp on the
throttle body.
3. Unlatch the 4 metal clips that hold the
factory air cleaner lid to the base. Next dis-
connect the breather hose that attaches to the
rear of the air cleaner lid.
4. Remove the factory intake tube, and lid from
the vehicle as an assembly.
5. While rocking the factory air cleaner base
back and forth, pull up, and remove it from the
vehicle. There are no bolts holding it down, just
grommets.
6. Remove the 2 lower grommets from the
factory plastic air cleaner mount.
7. With a 10mm socket, remove and save the
bolt from the factory plastic air cleaner mount. It
will be re-installed in step #12.
8. With a 10mm socket, remove and save the bolt
that holds the radiator to the radiator support. It
will be reused in step #10.
9. Install the 2 well nuts (#18) into the holes
in the plastic air cleaner mount where you
removed the grommets in step #6.
10. Insert the bolt, removed in step #8, thru
the round hole in the provided L-bracket, and
back into the radiator support. Leave the bolt
slightly loose for now.
11. Assemble the Cool Air Dam panels (#3 & 4)
as shown, using the seven 6-32 screws (#10), flat
washers (#11), and keps nuts (#12).
12. Install the CAD into the vehicle. Install
the two 3/8 x1 1/4” button head bolts (#13),
thru the bottom panel, and into the well nuts.
Reinstall the factory bolt removed in step #7
thru the panel, and into the fender well.
Tighten all three bolts at this time.
Installation Instructions
For Part Numbers:
310-208
700-471 Airaid Oiled Media Filter
311-208
701-471 SynthaMax Dry Media Filter - Red
312-208
702-471 SynthaMax Dry Media Filter - Black
313-208
703-471 SynthaMax Dry Media Filter - Blue
2007-11 Jeep Wrangler (JK)
3.8L V6
Component Identification
1.
Airaid Premium Filter
1
2. Airaid Intake Tube
1
3. MAF Panel
1
4. Bottom Panel
1
5. Reducing Hump Hose
1
6. Weather Strip 20”
1
7.
1/4-20x1/2” Button Head Bolt
3
8.
1/4” Flat Washer
3
9.
1/4” Serrated Nut
1
10.
6-32x 5/16” Screw
7
11.
#6 Flat Washer
7
12.
6-32 Keps Nut
7
13.
3/8-16x1 1/4”Button Head Bolt
2
14.
Bracket
1
15.
#44 Hump Hose
1
16.
#52 Hose Clamp
1
17.
Grommet
1
18.
Well Nut
2
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.