Airaid 400-217 - Manual

Installation Instructions
For Part Numbers:
400-217
700-445 Airaid Oiled Media Filter
401-217 701-445 SynthaMax Dry Media Filter - Red
402-217 702-445 SynthaMax Dry Media Filter - Black
403-217 703-445 SynthaMax Dry Media Filter - Blue
2007-08 Ford F-150 4.6L V8
Component Identification
1. Airaid Premium Filter 1
2. MAF Panel 1
3. Bottom Panel 1
4. Airaid Intake Tube 1
5. Filter Adapter 1
6. Urethane Hump Hose 1
7. Reducer Coupler 1
8. Weather Strip 24 3/4” 1
9. 6-32 x 5/16” Screw 7
10. #6 Flat Washer 7
11. 6-32 Keps Nut 7
12. ¼ - 20 x 7/8” Bolt 5
13. ¼” Flat Washer 12
14. Bushing 3
15. ¼ - 20 Locknut 5
16. Gasket 4 ½” 1
17. Rubber Grommet 2
18. M6 - 1 x 25 Hex Bolt 1
19. Long/Narrow Bracket 1
20. Black Plastic Hose Mount 1
21. Aluminum Fitting 1
22. Rubber Grommet 1
23. #48 Hose Clamp 1
24. #52 Hose Clamp 1
25. #80 Hose Clamp 2
26. M6x1x20 Button Head Bolt 1
1. Disconnect the negative battery cable.
Unclip the factory airbox from the factory Mass Air
Flow (MAF) sensor housing. 2. Remove the factory air filter and airbox from the
vehicle. Pull straight up on the airbox, to release it
from the grommets, and then remove the airbox inlet
from the drivers side fender.
4. Using a 5/16” socket, ratchet and extension, remove
one bolt from the factory coolant reservoir mount. 6. Insert three ¼-20 x 7/8” bolts (#12), and ¼” flat
washers (#13) through the CAD. Place one bushing
(#14) at each hole between the CAD and the filter
adapter (#5). Next, secure the assembly using three
¼” flat washers (#13), and ¼-20 locknuts (#15). 5. Assemble the Airaid Cool Air Dam (CAD) panels
(#2, #3) using seven 6-32 x 5/16” screws (#9), #6 flat
washers (#10), and 6-32 keps nuts (#11).
Bushing
3. Slide the green tab on the factory breather hose,
and remove it from the factory intake tube. Using a
5/16” socket, loosen the hose clamps on each end of
the factory intake tube and remove it from the en-
gine.
9. Remove the two factory grommets from the facto-
ry airbox mounting plate. 8. Install the rubber grommet (#22), and aluminum
fitting (#21) into the Airaid Intake Tube (#4). 7. Install the gasket (#16) onto the filter adapter.
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.