Airaid 450-329 - Manual

Installation Instructions
For Part Number:
450-329
2015 Ford Mustang GT
5.0L V8
2. Remove the strut tower brace is so equipped. Lift up
on the engine cover to unseat it from it’s mounting
grommets and set it aside. 3. Disconnect the 3 breather lines and resonator tube from
the intake tube. Loosen the hose clamps and remove the
factory intake tube.
4. Gently pry the MAF harness anchor out of the airbox
and disconnect the Mass Air Flow meter. 5. Remove the 6mm airbox mounting bolt in the inner
fender and lift the entire airbox assembly out of the
vehicle. Set the bolt aside for now. It will be reused. 6. Remove the entire resonator assembly from the vehi-
cle. It is held in place with two plastic retainers and a
single 6mm nut on the firewall.
8. Remove the protective film from the Panels and cre-
ate the assembly as shown using 4 1/4 -20 Button Head
Screws and Lock washers. 9. Install the Filter Adapter onto the Panel Assembly as
shown, using the three 1/4-20 Button Head Screws and
Flat Washers.
Component Identification
1 Airaid Track Day Filter 1
2 Airaid Intake Tube 1
3 Top Panel 1
4 Bottom Panel 1
5 Reducing Coupler 1
6 Hump Hose 1
7 Filter Adapter 1
8 Weatherstrip 23" 1
9 1/4" Flat Washer 3
10 8-32 Button Head Screw 2
11 1/4-20 Button Head Screw 3
12 ¼"-20 Button Head Screw 4
13 #56 Hose Clamp 1
14 #64 Hose Clamp 1
15 #68 Hose Clamp 2
16 1/2" ID Grommet 2
17 Aluminum Fitting 2
18 Aluminum Fitting 1
19 Resonator Cap 1
20 1-¼" Speed Clamp 1
21 13/16" ID Grommet 1
22 3/8” Grommet 1
23 Firewall Plug (not shown) 1
24 ¼" Lock Washer 4
1. Remove the battery box cover in the cowl and discon-
nect the negative battery terminal.
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
1
2
3
Resonator
Anchor
MAF
7. Be sure the speed clip remains inside the vehicle. It
will be reused.