JBL Synthesis SAM1HF User Manual
Page 13
I
NPUT
/O
UTPUT
A
SSIGNMENTS WITH
P
ASSIVE
C
ROSSOVER
The SDEC-3000 supports up to 7.1 input with up to 7.1 output. The input and output assignments are as described
in the below chart. You must make the correct connections from the surround processor output to the amplifier input
for the system to work correctly. Please refer to the connection diagram for more information.
The correct Synthesis Interconnect kit includes all the necessary connections for using the SDEC in the Synthesis sys-
tem. Please be sure to order the S3000IC for use with SDEC-3000 and S4000IC for use with SDEC-4000. Retrofit kits are
also available. Please contact JBL Synthesis Technical Support for more information at (888) 691-4171 (USA only).
C
ONNECTION
N
OTES
• Please follow the wiring diagram and the Input/Output Assignments chart for correct connections.
• You will need to use the Ethernet network port on the rear panel of the unit for the final calibration process.
You can use a crossover network cable if you plan to connect directly to the SDEC-3000 from a computer.
Alternatively, you can connect the SDEC-3000 through any standard Ethernet hub.
• When using the SDP-40 processor, make sure the subwoofer (in speaker setup) is set to Mono output and connect
to the Subwoofer Left output. Do not use the LFE output.
C
ONNECTING THE
S
PEAKER TO THE
R
EST OF
Y
OUR
S
YSTEM
S
SD
DEEC
C--3
30
00
00
0 O
Ouuttppuuttss ttoo A
Am
mpplliiffiieerrss
S
S3
30
00
00
0IIC
C
N
Nuum
mbbeerr
C
Chhaannnneell
S
SD
DEEC
C--3
30
00
00
0
9
LEFT FRONT
C1
10
RIGHT FRONT
C2
11
CENTER FRONT
C3
12
LEFT SIDE
C4
13
RIGHT SIDE
D1
14
LEFT REAR
D2
15
RIGHT REAR
D3
16
SUBWOOFER
D4
S
Suurrrroouunndd P
Prroocceessssoorr ttoo S
SD
DEEC
C--3
30
00
00
0 IInnppuuttss
S
S3
30
00
00
0IIC
C
N
Nuum
mbbeerr
C
Chhaannnneell
S
SD
DEEC
C--3
30
00
00
0
1
LEFT FRONT
A1
2
RIGHT FRONT
A2
3
CENTER FRONT
A3
4
LEFT SIDE
A4
5
RIGHT SIDE
B1
6
LEFT REAR
B2
7
RIGHT REAR
B3
8
SUBWOOFER
B4
(Mono Sub Left)
13
NOTE: Place the SAM12x
passive crossover as close
to the speakers as possible.
The SAM12x has a single
speaker level input and multiple
outputs for the SAM1HF and
SAM2LF speaker modules.
SAM1HF, SAM2LF OM.qxp 4/24/07 9:40 AM Page 14