Lanzar WDN2000.1D - Manual (Page 2)

WDN2000.1D
POWER STATUS
MIN
LEVEL
SUBSONIC
PHASE
l p f
MAX 50Hz 150Hz 0dB 12dB 20Hz 50Hz
L
R
LINE IN
REMOTE
0 180 GREEN=ON
RED=PROTECTION
HI-LEVEL
L R
BASS BOOST
1
6 3 5 2
8 7 4
9
WDN800.2D
GREEN=ON
RED=PROTECTION
POWER STATUS
LOW
PASS
FULL
CROSS OVER
HIGH
PASS
0 180
PHASE
MIN
LEVEL BASS BOOST H P F L P F
MAX 50Hz 150Hz 50Hz 150Hz 0dB 12dB
L
L R
R
LINE IN
HI-LEVEL
6 3 5 2
9
4
8 7 1
1.Line Input RCA J acks: These inputs are for signal cables
from the source.
2 .Input Level Control: Enables the matching of input levels
to the output levels from the source.
3.V ariable Bass Boost: 0 ~ 12 dB
4 .Crossover M ode: Low pass, F ull range or H igh pass
5 .H igh Pass F ilter: V ariable from 5 0 H z to 15 0 H z
6 .Low Pass F ilter: V ariable from 5 0 H z to 15 0 H z
7 .Phase Switch: 0 ° or 180 °
8.H igh Level Input: If your head unit does not have RCA
outputs, use the speaker outputs for the audio source.
9 .Power & Protection Indicators: The bi-color LED glows
green when power is on and no problems are present.
If one of the protection circuits comes on, it will change
to red.
1.Line Input RCA J acks: These inputs are for signal cables
from the source.
2 .Input Level Control: Enables the matching of input levels to
the output levels from the source.
3.V ariable Bass Boost: 0 ~ 12 dB
4 .Remote Bass Control: Remote controls the subwoofer level.
5 .Subsonic: This setting acts as a low frequency cut off for your
subwoofer. The subwoofer will not play frequencies below the
subsonic setting.
6 .Low Pass F ilter: V ariable from 5 0 H z to 15 0 H z
7 .Phase Switch: 0 ° or 180 °
8.H igh Level Input: If your head unit does not have RCA
outputs, use the speaker outputs for the audio source.
9 .Power & Protection Indicators: The bi-color LED glows
green when power is on and no problems are present. If
one of the protection circuits comes on, it will change to red.
WRATH 1