Powerplus POWXG9020 HIGH PRESSURE CLEANER 1500W EN - Manual (Page 6)

POWXG9020
EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
 Check especially the insulation of the electric cable should be faultless and without any
cracks. If the electric cable is damaged, an authorized local service centre should replace
it.
WARNING: High pressure jets can be dangerous if subject to misuse. The
jet must not be directed at persons, live electrical equipment or the
appliance itself.
WARNING: Do not use the appliance within range of persons unless they
wear protective clothing.
 Do not direct the jet against yourself or others in order to clean clothes or foot-wear.
 Hold the spray lance firmly with both hands.
 The operator and anyone in the immediate vicinity of the site of cleaning should take
action to protect them from being struck by debris dislodged during operation.
 Wear goggles and protection clothes during operation.
 Disconnect from electrical power supply before carrying out user maintenance.
 To ensure appliance safety, use only original spare parts from the manufacturer or
approved by the manufacturer.
 Do not use the appliance if a supply cord or important parts of appliance are damaged,
e.g. safety device, high pressure hose and trigger gun.
 Do not use the appliance with wet hands. If the appliance is humid or wet, unplug it
immediately. Do not put it in water.
 Tires and tire valves may be damaged by the high-pressure jet and then burst.
 Never use the machine in an environment where there could be a danger of explosion.
 It is not allowed to clean asbestos- containing surfaces with high pressure.
 This high pressure washer must not be used at temperatures below 0°C
WARNING: High pressure hoses, fittings and couplings are important for
the safety of the appliance. Use only hoses, fittings and couplings
recommended by the manufacturer.
WARNING: Inadequate extension cables can be dangerous. Cables on reels
should always be completely unwinded to prevent the cable from
overheating.
 If an extension cable is used, the plug and the socket must be waterproof and comply with
the below-mentioned requirements for length and cable dimensions.

1.0 mm² max. 12.5 m

1.5 mm² max. 20 m
 If the electric cable is damaged, it must be replaced by the manufacturer or his service
agent or similarly qualified person in order to avoid a hazard.
6.1 Mains power connection
The following should be observed when connecting the high pressure washer to the electric
installation:
 The electric supply connection shall be made by a qualified electrician and comply with
IEC 60364-1
 It is recommended that the electric supply to this appliance should include either a residual
current device that will interrupt the supply if the leakage current to earth exceeds 30 mA
for 30 ms.