Ericsson NPC-50 - Manual (Page 8)

Setting The RF Frequency
Refer to Table 1 (VHF) or Table 2 (UHF) for the DIP
switch setting for the desired operating RF fre-
quency of the radio. The DIP switch bank is located
in the upper right hand corner of the battery com-
partment. Use a pencil point or small object to posi-
tion the DIP switches to the corresponding setting.
Opening The Battery Compartment
Each radio has been pre-programmed to
operate on 151.6250 (VHF) or 464.5000 (UHF)
MHz.
NOTE
The battery pack is protected with a plastic
wrap. Do not remove this because damage to
the battery may result.
1. Unlock the
battery com-
partment by
pushing on
the latches
on either
side.
2. Remove the
cover by
sliding it
down and
away from
the radio.
CAUTION
8