Impact 180Ws Monolight Starter Flash with LED Modeling Light - Manual (Page 5)

5
Setup
Preparing the Monolight for Use
To begin using the SF-ABRL180, first remove the protective cap by turning it
counterclockwise and pulling it off the flash head.
Mounting on a Light Stand
Loosen the locking knob and place the receiver over
the light stand’s 5/8-inch stud.
Make sure the stud is fully inserted into the receiver
before tightening the locking knob until secure.
Adding a Reflector or Speed Ring
The SF-ABRL180 monolight has a Bowens mount for
light-shaping accessories. This allows you to attach optional add-ons such as a
reflector, beauty dish, or speed ring for a softbox.
To add a reflector, beauty dish, or speed ring:
1. Match up the three tabs on the back of the
accessory with the three slots on the flash head.
2. Press in and turn clockwise until the accessory is
fully seated inside the mount.
2