Canon 8x20 IS Image Stabilized Binoculars - Manual (Page 8)

ENG-7
Loading the Batteries
The binoculars are equipped with the Image Stabilizer that uses one
CR123A lithium battery.
z
Be sure not to use batteries with a nominal voltage rating of 3.0V or
higher or batteries which have no nominal voltage.
1 Open the cover.
z Open the battery chamber cover.
2
Insert the battery.
z Release the surface fasteners and open
them out to the left and right.
z Load the battery in the correct [+] [–]
orientation as indicated at the bottom of
the battery chamber.
z When loading the battery, insert the [–]
pole against the spring electrode inside
the battery chamber, and then push it in
as far as it will go.
Surface fasteners
3
Fix the battery firmly in place
with the surface fasteners.
z Wrap the surface fastener shown on
the left in the illustration around the
battery, and then wrap the right-hand
surface fastener around the battery
from above to fix it firmly in place.
Check to make sure that the surface
fasteners are not loose.
z Once the battery is in place, firmly
close the battery chamber cover.