Operating lomograflok 4×5 instant back – Lomography LomoGraflok 4x5 Instant Back User Manual
Page 8
8
6.
Your LomoGraflok is now ready to use.
opErating lomograFlok 4×5 instant Back
1.
Slide in the Film Plane Calibration & Mask Attachment
[13]
between the ground glass on your 4×5 camera and camera
body (the slot for inserting standard 4×5 film holder).
2.
Open the lens/camera shutter, adjust the camera bellows length
until you see an approximate sharp image on the ground glass
and focus your subject in detail.
3.
Close the lens/camera shutter.
4.
Remove the Film Plane Calibration & Mask Attachment
[13]
.
5.
Install the LomoGraflok onto the Graflok back of your 4×5 camera.
If the spring back on your camera can open 50 mm or more, you
may also simply slide in the LomoGraflok for shooting.
6.
Switch on the LomoGraflok by switching the On/Off Switch
[1]
.
7.
Remove the Dark Slide
[4]
from the back.
8.
Release the shutter and shoot.
9.
Put back the Dark Slide
[4]
.
10.
Detach LomoGraflok from the Camera.
11.
Press the Film Ejection Button
[2]
to eject the film.