Creality Halot-Lite Resin 3D Printer - Manual (Page 10)

5. Level Platform
1. To calibrate the printing platform, first raise the platform, loosen the
fixing screws on the left and right sides of the material trough, and
take out the material trough;
2. Loosen the four Leveling screw
of the prototyping platform, attach Calibration
card tightly to the print screen, press
Settings → Z Axis Motion → Levelling（Refer
to operating steps of levelling platform 2 for
operation.）, to check whether the platform
fits evenly with the paper.
3. After confirming that Calibration card
fits evenly with the platform, screw up
the four screws of the platform.
Note: The printing platform has been leveled at the factory. If it needs leveling due to transportation or other reasons, please follow the steps
below to adjust the printing platform.
06