IK Multimedia iLoud Precision MTM Active 2-Way 175W Dual 5" Studio Monitor (White, Single) - Manual (Page 18)

English
18
The procedure will need to be repeated for each of the speakers in the system, paying attention placing the
microphone in the same spots for each position for both the speakers.
NOTE: the measurement signal level is independent from the volume control. The audio test signal level is fixed
and optimised for best performance.
TIPS: in order to facilitate the calibration operation, it is also possible to perform the four measurements leaving
the microphone at the same spot. This way you don’t have to worry about placing the microphone in the same
positions between the different speakers in the setup.
From the control software
To perform a custom calibration from the control software, please follow the instructions given in the control
software’s manual.
5. Factory reset
The system can be reset to its factory defaults by holding both CAL/PRESET and AUTO STANDBY buttons for
three seconds.
All back LEDS will flash five times for 1 second and the system will revert to its original factory state, including
empty the custom CAL curve and factory assignment for the remote control.
6. Hardware remote control
The iLoud Precision remote control (sold separately) can be conveniently placed on a mixing desk, near the
monitoring section or any place is the most comfortable to be operated.
This little remote allows you to switch the monitor voices as if more than one pair of monitors were actually
setup in the studio, or conveniently perform the ARC calibration process from the seating position.