EMI S2HB User Manual
Page 6
www.enviromaster.com
6
multi-zone Heat Pump Condensing units
8. Check wiring diagram for the re-
quired number of low voltage wires
to be run between indoor and out-
door sections.
9. Connect the 24 Volt wiring matching color
to color. Refer to the wiring diagram on the
inside panel of the condenser, and also
refer to the wiring diagram on the indoor
unit. Low
Volt interconnect should be at
least 18
AWG.
10. T
o replace side panel slide the slotted
holes of the panel onto the loosened
screws of the front
panel so that the
edge of the front
panel covers
the edge of the
side panel.
11. Tighten all remaining loose screws.
S2HB ElEctrIcAl WIrIng InStAllAtIon SEctIon
Plastic edge guards
High Volt
Low Volt
Wire diagram
Inside electrical
access panel.
low Volt Connection
Completed
electrical Connections
Note:
Refer to the
units’ wiring diagram
for all wiring.