Honeywell Q7055A - Manual (Page 36)

BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN
36 EN1B-0198GE51 R0801
the parameters may be wrong is
acceptable.
exit exits the sub-shell and returns to the
main shell.
6.5.4 load - Load executable
The command load is a direct command which
immediately starts downloading the application
firmware image into the BNA based on the
download configuration defined by the command dc.
After loading the image into local memory the BNA
Bootloader starts copying the image into the local
Flash memory where it resides until updated the
next time.
load accepts optional command-line parameters.
Accepted command-line parameters are FTP-Server
IP-Address and/or filename. Command-line
parameters supersede the current download
configuration for these elements. Command-line
parameters in the load command scope can be used
to use an alternative FTP-Server for downloading
or to download another application firmware
image into the BNA device.
If load fails, then it needs to be checked whether the
correct download configuration has been defined.
In this case, the command dc test becomes useful.