Drive specifications, System requirements, Physical specifications – HP DVD100I User Manual
Page 15: Mounting, Chapter 2 drive specifications, P. 15, Chapter 2
hp dvd-writer
hp dvd-writer
hp dvd-writer
hp dvd-writer
dvd100i
dvd100i
dvd100i
dvd100i
Technical Support Solutions Guide 10/25/01
System Requirements
15
15
15
15
Chapter 2
Drive Specifications
This chapter describes the specifications for the hp dvd-writer dvd100i drive and is
organized as follows:
System Requirements
The hp dvd-writer dvd100i drive is an internal IDE DVD+RW/CD-RW drive with an
EIDE-(ATAPI), MMC compliant interface.
The hp dvd-writer dvd100i drive functions on a desktop PC that meets the following
minimum guidelines:
■
Windows 98, Windows 2000 Professional, and Windows Me (Windows NT 4.0
Workstation with SP5 for data storage applications only) (Future – Windows XP
Personal and Professional)
■
Data applications:
●
Pentium II 450Mhz or equivalent processor
●
64 MB RAM
■
DVD video disc creation applications:
●
Pentium III 800Mhz or equivalent processor
●
128 MB RAM
●
video capture capability
■
hard disk space available
●
150 MB for included software installation
●
5 GB for DVD disc creation
■
An IDE controller with available connector
NOTE:
NOTE:
NOTE:
NOTE:
Windows NT 4.0 Server, Windows 2000 Server/Advanced Server, and all
versions of Windows CE are not supported.
Physical Specifications
Mounting
■
The hp dvd-writer dvd100i drive is mountable in either horizontal or vertical
configurations.
■
Mounting screws = M3x10mm
■
The mounting screws should not extend into the drive more than 6mm.
for the positions of the mounting screws.