Harmar Mobility AL010 - Manual (Page 5)

Installing the Lift
Measure from Hitch Bar to ground
5-13"
13-15"
15-17"
17-19"
OMIT
STABILIZER
OMIT
STABILIZER
HITCH
POST
HITCH
ADAPTER
To prepare your lift for installation you muct connect the lift to the Hitch Post
and Hitch Adapter provided. Proper positioning is determined by the height of the vehicle hitch.
1. Measure the distance from the bottom of the hitch reciever on the vehicle to the ground.
2. Refer to Figure 1 below to determine correct placement of the hitch adapter.
3. Connect hitch post to lift.
Figure 1
Once you have determined correct configuration, connect the Hitch
Post to the Hitch Adapter following the diagram to the right using
hardware supplied (1/2 - 13 x 3- 1/2” HHCS and lock nuts).
Position the folded lift to the rear of the vehicle with the motor box
folded away from the vehicle. With assistance, carefully lift the unit
up to the Hitch Post and attach it using the 1/2” bolt, washers and
lock nut provided.