Rear panel connections, First time use – Hitachi 55HDS52 User Manual
Page 12
12
ቫ Subwoofer Out
Connect this SUB WOOFER OUT output to the
external audio component input using the sub
woofer cable provided.
ቭ Upgrade Card
This card slot is for future software upgrades.
HITACHI will notify you if a software upgrade is
required for your TV. In order to receive written
notification, please complete and return your
warranty card.
ቮ To Power Swivel Connector
Connects to the Power Swivel Table Top Stand.
ቯ CableCARD Slot
This slot is for the CableCARD that will be provided
by your local cable operator to gain access to
chosen cable channels. Please call your local cable
operator if this service is available before
requesting a CableCARD (also known as Point of
Deployment (POD) module).
1.
Connect a coaxial cable to cable terminal of
the Rear Panel Jacks.
2.
Insert the CableCARD into the slot (Top of card
should be facing towards you as shown
below).
NOTE: 1. A digital cable subscription is required.
2. Do not insert a PCMCIA card into the
CableCARD slot.
If the CableCARD is properly installed or removed, the
TV will display the following respective screens.
After the CableCARD is installed, wait until the second
screen below appears. The third screen below will
appear if a channel is not authorized for viewing. Press
the EXIT button to exit the second screen.
Please take note of all information on the screen (you
will provide this information to your cable operator).
Call your cable operator and give them the information
from the card to start your cable service.
NOTE: Please see Appendix E on page 80 for
additional CableCARD information.
Rear Panel Connections
First time use
Digital Cable
INSERT
INSERT
INSERT
OR
CableCARD is not installed
CableCARD is installed
Not an Authorized Channel
In order to start cable service
for this device, please contact
your cable provider
CableCARD(tm): 123-456-789-1
Host: 123-456-789-1
Data: 123-456-789-1
Unit Address: 123-456-789-1
Press EXIT to return
OR
Acquiring Data.
Please wait.