Harman Stove Company OAKLEAF 1-90-797000 - Manual (Page 22)

22 Save These Instructions
Oakleaf Woodburning Stove
Dry Seasoned Wood Only! 3-90-798_R9
7
appliance set-up
a. Outside air attachment
Parts and Supplies Needed from Local Hardware
Stove: 1 piece of 4 in. (4.5 in. OD) aluminum flex
dryer vent (4 in. rigid aluminum duct is not a suitable
substitute and will not work) x needed length, 1 rodent
screen, aluminum tape and a trim ring for finished
around the outside air pipe inside the home.
1. Determine an appropriate hole location, through
the wall. Be sure there are no studs or other
supporting members. Also ensure there are no
electrical wires or plumbing contained within the
wall.
2. Make the hole through the exterior wall using a
hole saw or reciprocating saw. You'll want the hole
to be just slightly larger than the metal flex pipe.
3. Attach the rodent screen to one end of the flex
pipe, and insert it through the wall until the back
of the screen cover is against the outside surface.
4. Hold the flex pipe in place to make an accurate
determination of the length needed. Cut the flex
pipe to length.
5. Slide the trim ring onto the flex for the inside wall
portion.
6. Slide the other end of the metal intake flex pipe
into the stub on the rear of the Oakleaf and secure
it with aluminum tape. This air intake will supply
outside air for the secondary combustion within
the FireDome.
7. Secure the trim ring in place for finishing the inside
wall area.
8. Seal around the rodent screen on the exterior wall,
using silicone caulking.
Outside Air
Attachment
B. Leveling the appliance
To adjust the leveling bolts, you must first loosen
the locking nut. Turn the leveling bolt to the desired
position, and tighten the locking nut against the cast
iron leg.
C. Optional Cooking grill
The optional cooking grill #1-00-08121 installs easily
in the top load opening of the Oakleaf.
The grill handle (B) fits in the slots (C) on each side. To
remove the handle, lower and turn.
When installed, the grill hangs in the opening by the
hooks (A).
When grilling, you'll want to keep the fire size small and
the bypass damper in the open position. Depending on
the grilling being done, you may get grease dripping
on the glass causing it to become dirty and obstructed.
When you burn your next hot fire, the glass will likely
clean itself.
a
a
a
B
C
C
CauTION
neVer draw outside Combustion air from:
• wall, floor or Ceiling CaVity.
• ENCLOsEd spaCE suCH as aN aTTIC OR gaRagE