Air conditioner features, Continued), Check filter feature: you will see – FRIGIDAIRE 220211A243 User Manual
Page 9: Clean air feature, You will see, Remote sensing/follow me feature, Light on, On some models): light on, Light pulsing on & off intermittently, On some models)
.
.
.
.
.
9
Air Conditioner Features
(continued)
CHECK FILTER FEATURE:
YOU WILL SEE:
LIGHT On
CLEAN AIR FEATURE
(on some models):
LIGHT On
YOU WILL SEE:
DO THIS:
DO THIS:
PRESS CLEAN
AFTER CLEANING
PRESS CHECK
FILTER BUTTON
AIR BUTTON
Note: This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation. The LED (light)
will illuminate after 250 hours of operation. To reset after
cleaning the filter, press the “Check Filter” button and the light
will go off.
Note: When this feature is “ON”, the electronic air purifier is
energized to remove pollen and impurities from the air. To cancel
this feature, press the Clean Air button (the LIGHT will turn
off).
LIGHT pulsing On & Off intermittently.
ON
OFF
SET TEMP.
FAN SPEED
Mode
Energy Saver
Sleep
Light
Clock
Cancel
Timer
Fan
Reset
Lock
F
Clean Air
Follow Me
REMOTE SENSING/FOLLOW ME FEATURE
(on some models)
:
DO THIS:
PRESS REMOTE
SENSING/FOLLOW ME
BUTTON ON
NOTE:
Remote display is actual
temperature at remote control only.
ON
OFF
SET TEMP.
FAN SPEED
Mode
Energy Saver
Sleep
Light
Clock
Cancel
Timer
Fan
Reset
Lock
F
Clean Air
Follow Me
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing button. Next, use the
buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself). The
LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal.
It will con-tinue to send this signal until the feature is deactivated by pressing the remote sensing button. If the unit does not receive the
remote sensingsignal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has ended. The display on the
remote control indicates the temperature at the remote ONLY. The unit display indicates the set temperature.
Note: Unit display shows
“set” temperature