FRIGIDAIRE FPWD2785KF - Manual (Page 3)

Warmer Drawer
FPWD2785K F 27" Electric
Warmer Drawer / Wall Oven Combination Specifications
• To support Wall Oven when using in combination with Warmer
Drawer, two 3"-wide x 3/4"-thick planks must be installed as a base,
capable of supporting 200 Lbs. Do NOT use full base, since planks
are necessary to allow for proper air displacement.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Warmer Drawer Specifications
• Product Shipping Weight (approx.) – 55 Lbs.
• Voltage Rating – 120V / 450W / 60 Hz / 15 Amps
• Connected Load (kW Rating) @ 120 Volts = 0.5 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
• Amps @ 120V = 3.8 Amps
• Recommended Circuit Breaker – 15 Amps
• Always consult local and national electric codes.
• Full plywood base required, capable of supporting 100 Lbs.
• Base must be level and cabinet front must be square.
• Warmer Drawer can be used alone, or is approved to be used in
combination with any approved Frigidaire® 27" Electric Single Wall
Oven. (Refer to Combination Installation Specifications and drawing
on this page.)
• Warmer Drawer is approved to be used in combination with any
Frigidaire® Built-In Microwave and /or Electric Single Wall Oven.
Warmer Drawer Stand-Alone Installation
27" Warmer Drawer/27" Single
Wall Oven Combination Installation
Warmer Drawer Stand-Alone Installation
27" Warmer Drawer/27" Single
Wall Oven Combination Installation
USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca
FPWD2785K 02/11 © 2011 Electrolux Home Products, Inc. Printed in the U.S.A.
Specifications
subject to change.
Accessories information available
on the web at frigidaire.com