FUJITSU FI-553PR - Manual (Page 9)

fi-553PR Imprinter Operator’s Guide | 7
2.3. Operation Test
After installing the Imprinter, check if the printing operation
can be done in the Offline Print Test mode of the scanner.
1. While pressing [Function] button on the operator
panel, press button.
Keep pressing [Function］ button.
2. Release [Function] button when the Function
Number Display changes from [P] to [b].
3. Place a blank document on the ADF paper chute.
ATTENTION
●
Use A4 or Letter size paper. If the size is
smaller than A4 or Letter, printing may not be
completed successfully.
●
Confirm that the Print Cartridge is positioned
within the document width.
4. Press [Scan] button.
Ö The paper is fed into the ADF. Test pattern 1 (c of
the right figure) is printed on the paper starting 5mm
(the range of error is ±4mm) from its leading edge.
HINT There are following print test patterns:
Test pattern 1 (
c)
(Horizontal) :
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`0000
0000
Test pattern 2
( 2)
(Horizontal) :
abcdefghijklmnopqrstuvwxyz{|}~ 00000000
Test pattern 3 ( 3)
(Horizontal):
!”#$%&()*+,-./0123456789:;<=>?@00000000
Test pattern 4
( 4)
(Vertical):
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`00000000
Test pattern 5 ( 5)
(Vertical):
abcdefghijklmnopqrstuvwxyz{|}~ 00000000
Test pattern 6 ( 6)
(Vertical):
!”#$%&()*+,-./0123456789:;<=>?@00000000
When multiple sheet of documents are set on the
ADF, the Test print repeats the Pattern from 1 to 6.
The numbering data portion ”00000000” changes
from 0 (Zero) with increment of 1(one).
5. To stop Offline Print Test mode, press button.
The scanner will be turned off.
Function Number Display
Function Function
Function
Send to
Scan
5mm
Feeding direction
Test pattern print sample
6
5
4
3
2
c