Firestone Intelli Ride 2230 - Manual (Page 4)

Battery Connection
Connections to be made with
vehicle interior
Program button. This is discon-
nected after programming and
replaced with the Park Wire.
Connector to ECU, to be mounted
inside the vehicle.
Service Switch to be used
to turn the system on and
off.
Ignition wire and ground wire.
Ignition wire should be connected
to a source less than 1/2 amp.
Grommet to be used if needed
in the firewall.
Height Control
Switch
Compressor Relay
To be mounted inside engine bay.
Figure 1