Genicom MatrixPrinter LA36 - Manual (Page 21)

2-4
2.4 2.4 2.4 2.4 2.4 Inspection after Unpacking Inspection after Unpacking Inspection after Unpacking Inspection after Unpacking Inspection after Unpacking
1. Carefully check the printer and the accessories for visible damage.
2. Install the cut-sheet stand (Figure 2.4). The cut-sheet stand enables smooth feeding of not only cut sheets
but continuous forms, and its paper guides position cut sheets for printing.
3. Install the platen knob.
4. Install the ribbon cartridge. See the Installation Guide for details.
5. Check the rated voltage for the printer and AC power outlet, then connect the AC power cord between the
printer and AC power outlet.
6. Close the front cover.
7. Turn on the power switch.
8. Load a cut sheet or continuous forms as explained in the Installation Guide.
Check printing performance and quality using self-test printing, detailed in Section 4.10.1 “Self-test print-
ing”.
Figure 2.4 Installing the cut-sheet stand
Mounting pins
Cut-sheet stand
Paper guides