Grandstream Networks GXP-2020 - Manual (Page 27)

Grandstream Networks, Inc. GXP–2020 Users Manual Page 27 of 33
Firmware 1.1.4.3 Last Updated: 05/2007
Syslog Level Select the ATA to report the log level. Default is NONE. The level is one of DEBUG,
INFO, WARNING or ERROR. Syslog messages are sent based on the following events:
• product model/version on boot up (INFO level)
• NAT related info (INFO level)
• sent or received SIP message (DEBUG level)
• SIP message summary (INFO level)
• inbound and outbound calls (INFO level)
• registration status change (INFO level)
• negotiated codec (INFO level)
• Ethernet link up (INFO level)
• SLIC chip exception (WARNING and ERROR levels)
• memory exception (ERROR level)
The Syslog uses USER facility. In addition to standard Syslog payload, it contains the
following components: GS_LOG: [device MAC address][error code] error message
For example: May 19 02:40:38 192.168.1.14 GS_LOG: [00:0b:82:00:a1:be][000].
Ethernet link is up.
NTP server This parameter defines the URI or IP address of the NTP (Network Time Protocol) serve.
It is used to display the current date/time.
Distinctive Ring
Tone Caller ID must be configured. Select a Distinctive Ring Tone 1 through 3 for a particular
Caller ID. The GXP will ONLY use selected ring tones for particular Caller IDs. For all
other calls, the GXP will use System Ring Tone. When selected and no Caller ID is
configured, the selected ring tone will be used for all incoming calls.
Disable Call
Waiting Default is No. If set to Yes, the call waiting will be disabled.
Use Quick IP
Call Mode Dial an IP address under the same LAN/VPN segment by entering the last octet in the IP
address.
In the Advanced Settings page there is an option "Use Quick IP-call mode". Default
setting is No. When set to YES, and #XXX is dialed, where X is 0-9 and XXX <=255,
phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the
local IP address REGARDLESS of subnet mask.
#XX or #X are also valid so leading 0 is not required (but OK). See Quick IP Call Mode
for details.
Lock keypad
update If set to “Yes”, the configuration changes via keypad are disabled.