Grizzly G1019 - Manual (Page 14)

-12- G1019 14'' Bandsaw
Figure 10. Drive pulley placed on shaft.
Figure 11. Place drive pulley.
9. Lay the stand on its side. Carefully set the
motor on the motor bracket (see Figure 11)
and line up the holes. Secure the motor
using (4)
5 ⁄
16
''-18 x 1'' hex bolts, (4) hex nuts
and (8) flat washers, finger tight only. Slide
the motor to the top of the stand as far as it
will go. Tighten the top two motor bolts down
leaving the bottom two finger tight. Set the
stand upright at this time.
8. Place the drive pulley on the motor shaft
and line up the keyways. Insert the key and
tighten down the pulley setscrew. See
Figure 10.
Drive Pulley
Figure 8. Attach right angle brace.
Figure 9. Install top panel.
6. Attach the right angle brace to the bottom of
the top panel using (2) 5 ⁄
16
''-18 x 1 ⁄
2
'' carriage
bolts, (2) flat washers and (2) hex nuts.
Finger tighten only. See Figure 8.
7. Install the top panel using (10) 5 ⁄
16
''-18 x 1 ⁄
2
''
carriage bolts, (10) flat washers and (10)
hex nuts. It may be necessary to wiggle the
panels a bit to line up the bolt holes. Finger
tighten only. See Figure 9.
Right
Angle
Brace
Top
Panel