Garmin Edge 500 - Manual (Page 29)

Edge 500 Owner’s Manual 5
ANT+ Sensors
2. Use a coin to twist the cover
counter-clockwise so the arrow on
the cover points to OPEN .
3. Remove the cover and battery.
4. Wait 30 seconds.
5. Insert the new battery with the
positive side facing up.
NOTE: Be careful not to damage
or lose the O-ring gasket on the
cover.
6. Use a coin to twist the cover
clockwise so the arrow on the cover
points to CLOSE .
Installing the GSC 10
Both magnets must be aligned with
their respective indication lines for the
Edge to receive data.
1. Place the GSC 10 on the rear chain
stay (on the side opposite the drive
train).
NOTE: Place the flat rubber pad
or the triangle-shaped rubber pad
between the GSC 10 and the chain
stay for stability.