Grizzly G0604 - Manual (Page 22)

-20-
G0604 6" X 56" Jointer
Starting the machine:
1. Read the entire instruction manual first!
2. Make sure the cutterhead guard is installed
and correctly adjusted ( Page 18).
3. Make sure all tools and foreign objects have
been removed from the machine.
4. Review SECTION 2 (Page 9) and connect
your machine to the power source.
5. Turn the jointer ON.
— The jointer should run smoothly with little
or no vibration.
— Immediately stop the jointer if you suspect
any problems, and refer to Page 31 to
troubleshoot/fix any problems before start-
ing the jointer again.
— If you need any help with your jointer call
our Tech Support at (570) 546-9663.
Loose hair and cloth-
ing could get caught in
machinery and cause
serious personal inju-
ry. Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly and operation.
Test Run
For your convenience, the adjustments listed
below have been performed at the factory and
no further setup is required to operate your
machine.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the
best possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in
SECTION 7: SERVICE.
Factory adjustments that should be verified:
1. Knife Height Settings (Page 33).
2. Table Parallelism (Page 36).
3. Outfeed Table Height Even w/Knives at Top
Dead Center ( Page 38).
4. Depth Scale Calibration (Page 40).
5. Fence Stop Accuracy (Page 40).
Recommended
Adjustments