GIGABYTE AMD Socket 939 Processor Motherboard GA-K8NF-9-RH - Manual (Page 76)

GA-K8NF-9-RH Motherboard - 76 -
English
(6) Configuring a bootable RAID array with Microsoft Windows 2000
Problem: Users cannot install Windows 2000 with Service Pack 2 (or previous versions) to a bootable
RAID volume.
There are two solutions to resolve this issue.
Solutions 1:
Use the NVRAID tool (nForce Driver Version 5.xx) to convert the boot volume to a RAID array. Here
are the detailed step-by-step instructions:
Step 1:
Install Windows 2000 onto a selected hard drive. Download and install Windows 2000 Service Pack 4
from Microsoft's website.
Step 2:
After system restarts, press Del to enter system BIOS Setup during POST (Power-On Self Test). Under
the Integrated Peripherals menu assure the SATA port connecting the SATA hard disk (the one
containing the Windows 2000) is Enabled (Figure 20). Save settings and exit the BIOS setup.
Figure 20
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
Integrated Peripherals
On-Chip IDE Channel0 [Enabled]
On-Chip IDE Channel1 [Enabled]
IDE DMA transfer access [Enabled]
On-Chip MAC Lan [Auto]
On-Chip LAN BOOT ROM [Enabled]
NV IDE/SATA RAID function [Enabled]
NV Serial-ATA 1 [Enabled]
NV SATA 1 Primary RAID [Enabled]
NV SATA 1 Secondary RAID [Enabled]
NV Serial-ATA 2 [Enabled]
NV SATA 2 Primary RAID [Enabled]
NV SATA 2 Secondary RAID [Enabled]
IDE Prefetch Mode [Enabled]
USB Memory Type [SHADOW]
AC97 Audio [Auto]
Onboard 1394 [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level