Tr-1 gladiator specifications, Preparation for installation – Garmin GLADIATOR TR-1 User Manual

Page 11

Advertising
background image

10

11

TR-1 Gladiator Specifications

Pump Set

10.75” L x 4.625” x 4.75”

Ignition Protected

ECU

6.5” H x 7” W x 2” D

Compass Ball

3.6”Diameter

Cable Length 20’

HH/Remote

5” x 2.5 x 1”

Cable Length 20’

Deckmount/On-Off

5/8” x 2.5 ”

Cable Length 10’

Battery Cable

12 gauge

Cable Length 8’

Tach Cable

Cable Length 13’

Warning Horn

Wire Length 9’

Shadow Drive

2-5/8” L X 1-1/4 Dia

Wire Length 9’

Supply Voltage

11.5-14.0

VDC

In line fuse

ATO 40 Amp

Operating Ambient Temperature

20 to 120 deg.F

Preparation For Installation

You will be hard mounting four components in your boat:1) The pump unit 2) The Deckmount switch 3) The

Compass Ball 4) The Electronic Control Unit (ECU). Other components to install include, Shadow Drive Valve,

Warning Horn, Battery Cable, Tachometer inputs, Handheld and optional is the NMEA (GPS) connections.

Spend some time to figure out where you are going to mount all of the components before you start to mount any

of them. Place components where you expect to mount them and verify you have access to, length, and routes for

the cables and hoses that connect the components. 10, 6, & 3 meter extension cables with the pico connectors

at both ends are available for extending the Handheld, Compass Ball, Deckmount, from TR-1. The Warning

horn and Shadow Drive may be extended using any 18-22 gauge wire. The Tach can be extended at the wire ends

by using shielded twisted pair, the cable end can be extended using a standard pico extension.

Tools Needed

Some tools will be required for installation of the autopilot. Drill and drill bits, Phillips

screwdriver, end wrenches, wire strippers, pliers, side cutters, hose cutter/pipe cutter, safety

glasses.

Other supplies that may be needed: Hydraulic fluid, rags, Helm/Hydraulic Bleeding Equipment.

Refer to helm bleeding instructions for proper tools required.

Mounting Screws & Wire Ties

Some mounting screws are provided. You may choose to drill and tap the mounting surface.

Some wire ties are included in the installation kit, but you may need more

depending on application.

Advertising