GM None Pontiac Aztek - Manual (Page 148)

Clean the inside of the windshield as needed to remove
any dirt or film that reduces the sharpness or clarity
of the HUD image.
To clean the HUD, spray household glass cleaner on a
soft, clean cloth. Wipe the HUD lens gently, then dry
it. Do not spray cleaner directly on the lens because the
cleaner could leak into the unit.
If the ignition is on and you cannot see the HUD image,
check to see if one of the following has occurred:
• Something is covering the HUD unit.
• The HUD dimmer knob is adjusted properly
• The HUD image is adjusted to the proper height.
• Ambient light in the direction your vehicle is facing,
is low.
• A fuse is blown. See Fuses and Circuit Breakers on
page 5-113.
If you ever have to have your windshield replaced, be
sure to get one that is designed for the HUD or your
HUD image may look blurred and out of focus.
Accessory Power Outlets
With accessory power outlets you can plug in electrical
equipment such as a cellular telephone or CB radio.
There is a single front power outlet located on the floor
console above the climate control system outlets.
There is one rear power outlet located in the rear of the
vehicle on the driver’s side.
To use the outlet, pull the cover down. When not using
it, cover the outlet with the protective cap.
Notice: Leaving electrical equipment on for
extended periods will drain the battery. Always turn
off electrical equipment when not in use and do
not plug in equipment that exceeds the maximum
amperage rating.
Certain electrical accessories may not be compatible to
the accessory power outlet and could result in blown
vehicle or adapter fuses.
3-22